DRUMMOND 1/6 HP Submersible Utility Pump, 1600 GPH max flow, 25 ft max head, 1″ NPT discharge w/ 3/4″ GHT adapter, thermoplastic housing, PSC oil-filled motor, 10 ft cord, CSA/UL listed, drains down to 1/4″

Condition: New, not used. Factory components included: DRUMMOND 1/6 HP submersible utility pump and 3/4″ garden-hose adapter. Capacitors, hoses, or check valves are not included.

Overview

This DRUMMOND 1/6 HP submersible utility pump (P/N 63319) is a compact, lightweight, clear-water dewatering pump designed for fast setup and reliable service in basements, crawl spaces, window wells, utility pits, garages, flat roofs, and job-site puddles. The PSC, oil-filled motor runs cool and quiet for long life, while the thermoplastic housing resists corrosion. With a 1″ NPT discharge and included 3/4″ GHT (garden-hose) adapter, it connects to common hose threads in seconds. The pump drains to within 1/4 in. of the surface (on a flat, hard bottom) and delivers up to 1,600 GPH (26 GPM) with up to 25 ft of head (zero-flow shutoff).

Tip: For best performance at long hose runs or higher lifts, use 1″ hose on the 1″ NPT outlet instead of a garden hose to reduce friction loss.

Features

• Fully submersible clear-water utility pump for temporary dewatering
• 1,600 GPH (26 GPM) max free-flow; 25 ft max head (0-flow)
• Drains to ~1/4 in. on flat, hard surfaces
• 1″ NPT discharge plus 3/4″ garden-hose adapter (included)
• PSC, oil-filled motor for efficiency and cooling; 60 Hz
• Thermoplastic housing—corrosion resistant and impact tolerant
• Easy-clean bottom screen to remove debris and maintain flow
• CSA & UL listed for safety compliance
• 10 ft power cord for flexible placement (indoor/outdoor as permitted)

Specifications

• Brand / Model: DRUMMOND 63319
• Horsepower: 1/6 HP
• Voltage / Frequency: 120 VAC, 60 Hz
• Amperage (FLA): 2.2 A
• Motor Type: PSC, oil-filled, continuous-duty capable in clear water
• Max Flow: 1,600 GPH (26 GPM) at minimal head
• Max Total Head: 25 ft (shutoff)
• Discharge: 1″ NPT female; 3/4″ GHT adapter included
• Minimum water level / drawdown: to 1/4″ (flat, hard bottom)
• Housing: Thermoplastic (green)
• Dimensions: approx. 8″ L × 8″ W × 13″ H (nominal)
• Unit Weight / Ship: ~8 lb / 9.45 lb
• Cord Length: 10 ft
• Certifications: CSA, UL

Performance varies with head height, hose length/diameter, and hose kinks. For best results, keep discharge lines short and straight, and run 1″ ID hose when practical.

Applications / Spheres of Application

• Emergency dewatering: flooded basements, garages, window wells, crawl spaces
• Roof & flat deck drainage (temporary water removal—verify roof load & electrical safety)
• Sumps/utility pits without a built-in float (manual on/off)
• Construction/MRO: puddle removal before patching, coating, or slab work
• Appliance & tank drain-downs: water heaters (post-cool), stock tanks, small pools/liners*
• Irrigation transfer and garden/yard water relocation (clean water)
  *Not for potable water or fish ponds unless materials and cleanliness meet your requirements.

Pros

• Fast hookup with garden-hose adapter—no special fittings required
• Lightweight & portable, easy to stage during storms
• Low drawdown to ~1/4″ minimizes mopping/squeegeeing
• PSC motor provides quiet operation and good efficiency for the class

Cons

• Manual utility pump (no built-in float); consider an inline float switch for automatic cycling
• Garden hose adds friction loss; use 1″ hose for higher flows at lift
• Intended for clear water; not a trash pump—screen out debris to avoid clogging

Recommended Accessories / Part of a Larger System

• 1″ discharge hose kit (lay-flat or reinforced PVC) with camlocks or barbed fittings
• Inline check valve (prevents backflow on shutdown)
• Piggyback float switch for automatic on/off
• Hose strainer pre-filter to keep the bottom screen clear on gritty floors
• GFCI protection and proper extension cord gauge when distance is unavoidable

Comparable Products (same class—verify specs for your use)

• Superior Pump 91250 (1/4 HP, thermoplastic utility, 1-1/4″ NPT + GHT)
• Wayne VIP50 (thermoplastic utility pump)
• Little Giant 5-ASP series (1/6 HP utility)
• Flotec FP0S130TS (1/6 HP utility)
• Wayne EEAUP250 (1/4 HP automatic utility)
• Green Expert & Homdox 1/6–1/4 HP utility pumps (various models)

Listed models are comparable, not necessarily identical. Compare HP, head curve, discharge size, duty cycle, and solids handling to your job.

Cross-Referenced / Alternative Model IDs

• DRUMMOND 63319 (this listing); often found under retailer SKU for 1/6 HP, 1600 GPH thermoplastic utility pump class.
• May be alternately described as “Submersible Utility Pump, 1600 GPH, 1/6 HP, 25 ft head, 1″ NPT” in catalogs.

Safety & Use Notes

• Always plug into a GFCI-protected outlet; keep connections dry and above water level.
• Do not run dry; ensure water covers the intake screen during operation.
• Not for sewage, hydrocarbons, or flammables. Clear/cold water only unless otherwise validated.
• After use, flush with clean water and rinse the bottom screen.

Related

submersible utility water pump; device to remove standing water; 1600 gph basement pump; 1/6 hp dewatering pump; 1 inch npt discharge pump; garden hose adapter pump; flat roof drain pump; window well pump; crawl space water removal; thermoplastic submersible pump; psc oil-filled motor pump; 25 ft head utility pump; clear water transfer pump; emergency flood pump; portable sump pump alternative

Common Requests:

1. “Can this pump run automatically?” → Add a piggyback float switch or external controller.
2. “What hose should I use for maximum flow?” → 1″ ID hose on the 1″ NPT port; avoid long/kinked garden hoses.
3. “Will it handle dirty water or leaves?” → Light debris only; clean the bottom screen frequently.
4. “How low will it pump down?” → To ~1/4 inch on a flat, hard surface.
5. “Is it okay for continuous duty?” → Yes for clear water, but monitor temperature and ensure constant submergence for cooling.

Trademarks: DRUMMOND™ and other brand names used above belong to their respective owners. Names are used solely to identify products and compatibility and do not imply endorsement or affiliation.

P122